type |
Aqueous poly-2-chloro-1,3-butadiene dispersion |
form of supply |
Aqueous polychloroprene colloidal dispersion with high crystallization rate |
use |
Aqueous dispersion |
Product basic performance
characteristic |
Numerical value |
Units of measurement |
method |
solid content |
55±0.5 |
% |
DIN 53 563 |
Other parameters*
characteristic |
Numerical value |
Units of measurement |
method |
Viscosity |
about 100 |
mPa·s |
DIN 53 019 |
PH |
about 13 |
|
DIN 53 606 |
density |
about 1.12 |
g/cm3 |
DIN 53 757 |
Minimum film forming temperature |
about 5 |
℃ |
DIN 53 787 |
Crystallization rate |
good |
|
According to Shore A hardness |
gel content |
Low |
|
Bayer method |
*The above data is for general information only and is not characteristic of the product.
application
Dispercoll® (Dispercoll®) C 84 is used in the formulation of water-based adhesives, used in shoemaking, construction, furniture, mattresses, automobiles and other industrial fields.
Package
120kg plastic drum, 1000L container, tank car.
store
Stored in the original airtight container at 23°C, the shelf life of Dabike® C 84 is 6 months. Storage temperatures above 30°C should be avoided. The storage temperature should not be lower than 5℃, otherwise the product will freeze and solidify. A solidified Radix® C 84 will be completely ineffective. The packaging container must be tightly closed and protected from direct sunlight, otherwise the evaporation of water will cause it to form a non-redispersible polymer film.
Waste Disposal .
Useless DIPPE® product residues should be incinerated in accordance with local regulations, and polymer dispersions should be handled under special supervision and must not contaminate soil or surface water.
Safety: Dangerous nature
According to the relevant European Community regulations and the corresponding regulations of special EU member states. This product is not classified as dangerous goods. According to the transport regulations, it is not classified as dangerous goods.
Countries outside the European Union must comply with regulations on classification, packaging, labelling and transport of hazardous substances in their respective countries.
Data on handling, product safety and ecology can be found in the Safety Data Sheet.
Avoid direct skin and eye contact with the product, it is recommended to wear goggles and protective gloves.
Adequate ventilation or respiratory protection should be maintained when the glue is being sprayed. Comply with any international regulations regarding the application of glues for dispersion systems in spray applications. In special applications, multi-component (usually two-component) systems are used, and depending on the chemical composition of the system, additional safety measures are to be developed.
扫一扫添加微信